By placing the wavlink extender into an electrical outlet, you can connect. Simple setup procedures allow for dual-band operation and a throughput of 1200Mbps.
Setting up a wavlinky WIFI AC1200 extender setup is pretty simple. Due to the plug-and-play nature of the device, it can connect to any network in only 15 seconds. Depending on your requirements, you can configure the wavlink AC1200 in the router, repeater, or access point modes. Remember that the wavlink Extender needs to be reset or altered whenever the mode is changed.
Wavlink AC1200 WIFI extender setup
Setup instructions for the wavlink AC1200 Extender are provided below:
- The wavlink WIFI extender and router are first set up in the same space.
- Ensure that at least 50% of the signals from your router reach the extension.
- Now switch on both your router and the extension.
- To see if the LED light has changed to green, wait a short while.
- After opening the wifi settings on your laptop, desktop, or mobile device, connect to the wavlink ac1200 extender setup.
- No password is required the first time because they will automatically connect to your device.
- After establishing a connection, they gave no indication that the internet was accessible before launching any web browsers.
- enter AP.setup
- To access the login screen, type setup or 192.168.10.1 in the address bar at the top of the screen.
- When you’re finished setting it, turn off your extender for 15 to 20 seconds before turning it back on.
- Use the wavlink wifi range extender settings to connect your device; the name is “SSID EXt” in your wifi list.
Note: If you continue to experience problems with your wavlinkAC1200 wifi extender, feel free to contact our professional or visit our official website, ap.setup.
Wavlink AC1200 Extender setup via Manual Method
Additionally known as web browser setup, the manual method. Follow the steps below to learn how to manually set up a wavlink WiFi Extender:
- The extender must be placed halfway between your router and the dead zone.
- Then verify that the extension is capturing at least 50% of the router signals.
- The wavlink AC1200 extender should now be turned on by flipping the extender mode switch.
- Hold on until the colour of the power LED changes to green.
- Next, enter the Wi-Fi settings on any of your devices—including a phone, tablet, or laptop—and connect to the wavlink wifi network name. It will seem as a WIFI-N or Victory extender.
- It will first seem to be an open network, therefore you will need a password to join it.
- “No internet” will appear once the connection has been successfully established.
- Now launch the browser on your device and enter 192.168.10.1. As the username, enter admin as the password. only lowercase.
- Select the network you want to expand, give it a name, and then type the password to confirm your selection.
- After all the changes have been implemented, you can connect your devices for few seconds while the system reboots.